connect two WiFi simultaneously
  QXbgObrvFwNo 2023年11月02日 44 0
ide



Q:

I am trying to add a virtual wireless interface to my debian squeeze system using iw.

The output of iw list is shown below:

root@alix:~# iw list
Wiphy phy0

I am using the command:

iw dev phy0 interface add wlan1 type station

to add the virtual interface wlan1 however this gives me the error:

command failed: No such device (-19)

If I use the command:

iw dev wlan0 interface add wlan1 type station

it passes fine however if I try use both wlan0 and wlan1 I get an error saying neither are unique and so that doesn't work for me.

Anyone any ideas what could be causing this? Thanks

=======================================================================================


A:

About the first error you get ("command failed: No such device (-19)"): You can either use

iw phy phy0 interface add <name> type <type>

or

iw dev wlan0 interface add <name> type <type>

As long as the physical names and the device names don't clash, you can also omit the phy/dev keywords and simply use

iw phy0 interface add <name> type <type>

About using both interfaces at the same time and the message about them not being unique:

This is probably because they both use the same MAC address. You can try to change the MAC address of the new interface before activating it.

ip link set dev <dev-name> address <new-mac-address>

A word about your interface modes:

My iw command (v3.4) says


Valid interface types are: managed, ibss, monitor, mesh, wds.


Not sure what "station" will do.

Also, if you're trying to operate the two interfaces in different modes, make sure your wlan card supports this:

iw list
[...]
Supported interface modes:
* IBSS
* managed
* AP
* AP/VLAN
* WDS
* monitor
* mesh point
software interface modes (can always be added):
* AP/VLAN
* monitor
interface combinations are not supported

Notice the last line.

=======================================================================================

A:

iw dev <devname> interface add wlan1 type station

​phy0​​​ here in ​​iw dev phy0 interface add wlan1 type station​​​ is a phyname, so you need change it to ​​​wlan0​


【版权声明】本文内容来自摩杜云社区用户原创、第三方投稿、转载,内容版权归原作者所有。本网站的目的在于传递更多信息,不拥有版权,亦不承担相应法律责任。如果您发现本社区中有涉嫌抄袭的内容,欢迎发送邮件进行举报,并提供相关证据,一经查实,本社区将立刻删除涉嫌侵权内容,举报邮箱: cloudbbs@moduyun.com

  1. 分享:
最后一次编辑于 2023年11月08日 0

暂无评论

推荐阅读
QXbgObrvFwNo